Pitch Curve
Hello,
In the heli courses videos
In your pitch curve video. To get the pitch curve -100/0/+100 with a value of -100 to -2 degrees. Where do you enter this value so as not to go below -2 because in the axon the settings are -11/+11
I have tried various parameters but I cannot reproduce your pitch curve.
I would like to understand. If you could help me .....
I changed Gyro and radio so I am starting with the axon and the Jeti DC16-II and I would not like to make a mistake.
Very cordially.
Gilles
2 Comments
Gilles, the Axon does not constrain you to -11/+11. The mechanical limits of your swash and pushrods determine that. You can use the Axon to reduce or offset collective AFTER you get the basic range set mechanically.
Start by resetting the Axon collective settings. In your radio use a 3-point curve on the collective and using that curve (along with endpoints) get the collective moving from -2 to +12 or 13. Adjust pushrods as needed.
The gyro can then be used to offset collective so that mid-stick corresponds to X degrees (your preference).
The videos in the heli course area should walk you through this.
Thank you. I will think about all this.