Best NON EPOXY for GRP to wood?
Michael Z.
Gang, I am sensitive to epoxy and can no longer be around it.. Having said this what IS the BEST adhesive for WOOD to GRP construction. (cost not a concern). Lets have some opinions. DELUXE makes an adhesive that looks good but not sure what it might be made of.
Thanks for reading
Grim
deluxematerials.comFusion75ml pack. Strongest acrylic adhesive for combinations of GRP, metal and wood and nearly all plastics such as PVC, styrene, acetate, acrylic. Extremely useful for bonding in high stress parts such as engine mounts, bulkheads, metal fasteners onto polyester, epoxy or carbon fibre GRP. Please note! Ca
4 Comments
Sorry, I did not catch I had "comments" turned off..
UHU Plus Endfest 300 here. I like its properties and goes where I want with setting the position of the assembly (gravity). I also use it as filler and sand it after 24h. Ex. misplaced hole: fill it and drill again. Sits very well in deep areas and air bubbles are evacuated on the top (very slowly).
I don't use the "fast drying version "of this product as I want monitor along the cure process, checkiing every 2-3 hours or so dependingt the parts.
I use a paint protecting tape to set the "frontiers", which can be easily removed after few hours, the sticky part being on glue side.
looks like EPOXY!.. sorry... again the idea here is what can I use that is NOT epoxy?
I understand. My concern is my eyes in my case as product is corrosive..
Protection is recommended anyway. I'm wearing nitrile gloves, hermetic googles (to vent time to time once fog starts to develop) and working in ventilated room.
I also avoid watching closely the parts without protection when applying epoxy or checking while curing.
In your case you could use a 3M mask with ad hoc filter if you don't find an alternative.
Hope you find a solution that works for you!