Vario Lama
Good H.Death of a Lama
Just when I started a chaptered story...
This is hard to post but I guess it is a part of the hobby.
This video is the last flight of this Lama.
I was fortunate to have a buddy tape the flight and the crash itself. As I was coming back from the turn I wanted to do another low pass but changed my mind and wanted to climb up. When I gave it the cyclic input the 2s LiPo could not handle the surge and just caved in. 26 cycles on a GensAce should handle three DS610, one DS650 and BD Axon (the lights were off during this flight) but as it appears it was a bit too much.
In a way I was fortunate, the altitude was low, the ground was soft (did not even bend the skids) and mechanics survived along with the tail rotor.
Canopy, lattice and main blades are gone so I guess I will not be rebuilding this one.
Lesson identified in this crash is to use the cable loom to power the BD Axon (something I was asking Gonzalo about when I noticed it in his build) and two 2s LiPos to power the electronics...
Klem
5 Comments on Chapter 2
That was hard to watch sorry for the loss
Dammit Mann. Was looking great until...
A moment...
B
Remember when I was asking you about the CB200 and Axon combo...
I was also asking Gonzalo as he uses the cable loom in his big Chinook... he told me that the reason is power redundancy to Axon and servos...
But for 47 flight I had no issues with Lama... until I did...
Gosh, so sorry.....it happens to all of us....
Sorry for the loss but spectacular for sure