Build Story
Roban 800 UH-1D Huey build thread
matthew S.Chapter 4 of 7
Attaching the tail, mounting the ESC and cable management.
Dec 4, 2024
During these steps I realistically installed and removed the mechanics at least 15 times. Very fun!
To attach the tail I used the supplied wood blocks that are pre made with threaded blind nuts. I ended up installing and drilling the tail first and then moving the mechanics around slightly to get it to fit properly that way the gap is even.
While the mechanics were removed I took the time to clean up my servo cables and other excess wiring. Especially the light system wiring. The next time I put the mechanics in the fuselage should be more semi permanent.
The build is going smooth so far, with no major snags.
How People Feel About Chapter 42 pilots reacted
3 Comments on Chapter 4
Yikes!! Life shouldn't be that hard but sometimes these models call for that level of perseverance.
I ran into an issue with the tail gears binding up and could not figure it out so I kept having to take the mechanics out. Wasn’t hard though.
Ended up finding the torque tube was pushing on the 45 degree gears too hard so I needed to extend the tube from the transmission about 1mm that gave it the right clearance.
Tedious but worthwhile work!