RAH Comanche "Attack Version"
X-Treme Mechanics
After six weeks of traveling and then trying to catch up the neglect around the home and farm I am finally seeing time again to spend with this project. I will start by saying that buying a model started by someone else can have it's advantage and disadvantage. I purchased this Comanche in a "bundle" package at a reasonable price but the X-Treme mechanics that were included did not line up with the work that had already been completed. My first decision was to try and remove the fenestron drive which had been installed very well but not useable with the included mechanics. After looking for the easiest and most reasonable path to reach my goal was to modify the X-Treme mechanics by removing 1 3/4 inches from the bottom of the frames and having a new main shaft made to have the main rotor positioned at the proper height in the fuselage. Not a hard task, just time consuming. I have replaced the fenestron drive gears with ones that will give me the necessary RPM for a successful fenestron along with a Spektrum A6350 Ultra High Torque servo. Using a 5035 motor will produce more than enough power for this model and by changing the gearing will save a lot of weight over using a seperate motor, esc and batteries to control the fenestron. Using aluminum servo mounts allowed me to place the servos where needed to keep the control rods lined up properly to the swashplate. Mounting everything on the main frames give me a nice compact unit where removing six screws and unplugging the tail rotor servo will allow very fast and easy removal. I took the 5035 motor to David Shealey for him to drill and tap the end of the motor shaft for securing a clutch. Once the main shaft and motor arrive it will not take long to get ready for a test flight to check my theory before paint. I will be updating this chapter as I progress.
Jon E.












