Ed Collins

Thats good news! thanks again everybody

Thank you all very much, the mechanics have not been dialed in 100% so there is some corrections to be made and thank you Darrell for your comment about the link. Scott, the point I'm pointing at is part of the main rotor and therefore the question about making longer or replacing with something...

Mc Master Carr has a wide selection of materials and shapes for this.

Wow! I can't tell how much this means to me, exactly what I was looking for, Thank you

The torque tube fits all the way down the tail boom, one more question I have if you don't mind is the main rotor shaft position in the fuselage. I don't see any measurements in the spec sheet for the fuselage, and if I mount the mechanics on the wood frame, I think it sits to far back, If I place...

Thanks for that information

Thank you, wanted to tell you I have been following your videos on face book with the Huey, love to see it when it is done. Thanks

I think I just need to find a local machine shop and ask if they can make one for me. Then find some linkage for it. Thanks

The shaft is 12 x 194.1mm or .472 x 7.641 the shaft is in the heli. I'm dry fitting everything before I cut grind or wreck it. measure several times cut once

Align Trex 800E Pro with Torque Tube.

Thanks for the reply, the wood frame once put in the fuse (not glued in) tips toward the front about 10 degrees. It actually rocks forward and backward sitting on the bench. The fuselage just sitting on the bench tips back about that with out landing gear attached. The landing gear also has some...

That's what I thought, I found the same thing with the widows. I opted to put the windows on the inside for the best fit. Thank you for the reply back, much appreciated.

Watched your video's, wish I had an answer for your paint. But I would like to ask what you used for the rivets, the material in the syringe and what size needle did you use?

Thank you both for the suggestions, looking at purchasing both items.

Nice job!

Thank you all

Thank you both for your reply's, this being my first scale build, I just want too sure.

They get cut in half and slide over the stubs

Got my answer to the stab. needs to be cut in half.

Same question, I'm building my first one same model. Do I cut the stubs off the boom or cut out the stabs to fit the stubs. Or cut out the bottom side of the stab to fit the stubs. Almost makes the most sense.

Thanks for the advice

Thanks Joe for the reply back, this is the tail boom and the stab is about 3/16 wider than what is in the picture, no holes, no bolts. Again, this is my first scale build. I have built planes (balsa) any suggestions will be helpful.